2009 Nissan Murano Owner's Manual - Page 352
2009 Nissan Murano Manual
Page 352 highlights
PUSH STARTING unnecessary electrical systems (lights, heater, air conditioner, etc.). 3. Remove vent caps on the battery (if so equipped). Cover the battery with a firmly wrung out moist cloth to reduce explosion hazard. 4. Connect jumper cables in the sequence as 1 ? * 2 ? * 3 ? * 4 ). illustrated (* If the battery is disconnected or discharged, the steering wheel will lock and cannot be turned. Supply power using jumper cables before pushing the ignition switch and disengaging the steering lock. 6. Keep the engine speed of the booster B at about 2,000 rpm, and start vehicle * A being jump the engine of the vehicle * started. Do not attempt to start the engine by pushing. CAUTION Continuously Variable Transmission (CVT) models cannot be push-started or tow-started. Attempting to do so may cause transmission damage. CAUTION Do not keep the starter motor engaged for more than 10 seconds. If the engine does not start right away, turn the ignition switch to the OFF position and wait 10 seconds before trying again. 7. After starting your engine, carefully disconnect the negative cable and then the positive 4 ? * 3 ? * 2 ? * 1 ). cable (* 8. Replace the vent caps (if so equipped). Be sure to dispose of the cloth used to cover the vent holes as it may be contaminated with corrosive acid. CAUTION . Always connect positive (+) to positive (+) and negative (−) to body ground (for example, as illustrated), not to the battery. Make sure the jumper cables do not touch moving parts in the engine compartment and that the cable clamps do not contact any other metal. B * . 5. Start the engine of the booster vehicle and let it run for a few minutes. 6-10 In case of emergency