2009 Nissan Titan Crew Cab Owner's Manual - Page 147

REMOTE KEYLESS ENTRY SYSTEM (if so equipped) VEHICLE SPEED SENSING DOOR LOCK MECHANISM ● All doors will be locked automatically when the vehicle speed reaches 15 MPH (24 km/h). ● All the doors will unlock automatically when the transmission is shifted into the P (Park) position. ● The lock and unlock mechanism work independently of each other: - Both the automatic lock and automatic unlock feature can be enabled. - The automatic lock feature can be enabled while the automatic unlock is disabled. - The automatic lock feature can be disabled while the automatic unlock is enabled. - Both the automatic lock and automatic unlock feature can be disabled. How to enable and disable the lock feature To activate or deactivate the vehicle speed sensing door lock mechanism, perform the following procedure. 1. Close all doors. 2. Turn the ignition switch to the ON position. 3. Within 20 seconds, push and hold the power door lock switch to the LOCK position for more than 5 seconds. 4. When activated, the hazard indicator will flash twice. When deactivated, the hazard indicator will flash once. It is possible to lock/unlock all doors, turn on the interior lights and puddle lamps (if so equipped), and activate the panic alarm by using the keyfob from outside the vehicle. Some settings for the keyfob, such as horn beep, can be adjusted. For vehicles without navigation system, refer to "Silencing the horn beep feature" later in this section. For vehicles with navigation system, refer to "Vehicle electronic systems" in the "Display screen, heater, air conditioner and audio systems" section later in this manual. Be sure to remove the key from the vehicle before locking the doors. The keyfob can operate at a maximum distance of approximately 33 ft (10 m) from the vehicle. The effective distance depends upon the conditions around the vehicle. As many as 5 keyfobs can be used with one vehicle. For information concerning the purchase and use of additional keyfobs, contact a NISSAN dealer. The keyfob will not function when: ● the battery is discharged. ● the distance between the vehicle and the keyfob is over 33 ft (10 m). The panic alarm will not activate when the key is in the ignition switch. How to enable and disable the unlock feature To activate or deactivate the automatic door unlock mechanism, perform the following procedure: 1. Close all doors. 2. Turn the ignition switch to the ON position. 3. Within 20 seconds, push and hold the power door lock switch to the UNLOCK position for more than 5 seconds. 4. When activated, the hazard indicator will flash twice. When deactivated, the hazard indicator will flash once. Pre-driving checks and adjustments 3-7