2009 Nissan Titan Crew Cab Owner's Manual - Page 235

BLUETOOTH௡ is a trademark owned by Bluetooth SIG, Inc., U.S.A. and licensed to Visteon. ● Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate surrounding noises (traffic noises, vibration sounds, etc.), which may prevent the system from recognizing voice commands correctly. ● Wait until the tone sounds before speaking a command. Otherwise, the command will not be received properly. ● Start speaking a command within 5 seconds after the tone sounds. ● Speak in a natural voice without pausing between words. ● If you want to go back to the previous command, you can say "Go back" or "Correction" any time the system is waiting for a response. ● You can cancel a command when the system is waiting for a response by saying, "Cancel" or "Quit." The system announces "Cancel" and ends the VR session. You can button on the steering also press the wheel at any time. Whenever the VR session is cancelled, a double beep is played to indicate you have exited the system. ● If you want to adjust the volume of the voice feedback, press the volume control switches (+ or -) on the steering wheel while being provided with feedback. You can also use the radio volume control knob. ● In most cases you can interrupt the voice feedback to speak the next command by pressing the button on the steering wheel. ● To speed the operation you can say multiple commands. For example, press the button then say "Phonebook, New entry" rather than "Phonebook." Wait for the voice feedback prompt then say "New entry". USING THE SYSTEM The NISSAN Voice Recognition system allows hands-free operation of the Bluetoothா Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to vehicle operation. Giving voice commands To operate NISSAN Voice Recognition, press and release the button located on the steering wheel. After the tone sounds, speak a command. The command given is picked up by the microphone, and voice feedback is given when the command is accepted. ● If you need to hear the available commands for the current menu again, say "Help" and the system will repeat them. ● If a command is not recognized, the system announces, "Command not recognized. Please try again." Repeat the command in a clear voice. Initialization When the ignition switch is turned to the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. When completed, the amber light on the overhead console illuminates and the system is ready to accept voice commands. If the button is pressed before the initialization completes, the system will announce "Hands-free phone system not ready" and will not react to voice commands. Operating tips To get the best performance out of the NISSAN Voice Recognition system, observe the following: Display screen, heater, air conditioner, audio and phone systems 4-69