2009 Nissan Titan Crew Cab Owner's Manual - Page 164

● If the battery cable is disconnected, or if the fuse opens, the memory storage function will be canceled and must be restarted before a stored memory position can be set again. Drive the vehicle over 25 MPH (40 km/h) to restart the memory storage function. You can also restart the memory storage function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than two times with the ignition key in the LOCK position. Once the memory storage function has been restarted, you can store a memory position. See "Memory storage function" earlier in this section. position with the indicator light blinking, and then the light will stay on for approximately 5 seconds. ENTRY/EXIT FUNCTION This system is designed so that the driver's seat will automatically move when the shift selector lever is in the P (Park) position. This allows the driver to get into and out of the driver's seat more easily. The driver's seat will slide backward: ● When the key is removed from the ignition switch and the driver's door is opened. ● When the driver's door is opened with the ignition key turned to LOCK. ● When the ignition key is turned from ACC to LOCK with the driver's door open. The driver's seat will return to the previous position: ● When the key is inserted into the ignition switch and the driver's door is closed. ● When the driver's door is closed with the key turned to LOCK. ● When the key is turned from ACC to ON while the shift selector lever is in the P (Park) position. The entry/exit function can be adjusted or canceled. For vehicles with navigation system, see "Comfort & convenience settings" in the "Display screen, heater, air conditioner, audio and phone systems" section of this manual. For vehicles without navigation system, see your NISSAN dealer. Restarting the entry/exit function If the battery cable is disconnected or if the fuse opens, the entry/exit function will be disabled. Drive the vehicle over 25 MPH (40 km/h) to restart the entry/exit function. You can also restart the entry/exit function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than two times with the ignition key in the LOCK position. The entry/exit function should now work properly. Selecting the memorized position Set the shift selector lever to the P (Park) position, then: ● Within 45 seconds of opening the driver's door, push the memory switch (1 or 2) or ● Turn the ignition switch to the ON position and push the memory switch (1 or 2). The driver's seat, accelerator and brake pedals, and outside mirrors will move to the memorized SYSTEM OPERATION The automatic drive positioner system will not work or will stop operating under the following conditions: ● When the vehicle speed is above 4 MPH (7 km/h). 3-24 Pre-driving checks and adjustments