2012 Nissan Altima Owner's Manual - Page 132
2012 Nissan Altima Manual
Page 132 highlights
NOTE: Following step 2, there are 30 seconds in which to initiate step 3. 3. Firmly press and release the programmed HomeLinkா button a second time to complete the training process. (Some garage door openers may require you to do this procedure a third time to complete the training.) The garage door opener should now recognize the HomeLinkா Universal Transceiver and activate when the HomeLinkா button is pressed. The remaining two buttons may now be programmed (if not yet programmed, follow steps 2 through 4 in the "Programming HomeLinkா" procedures earlier in this section). 3. Press and hold the hand-held transmitter button. 4. The HomeLinkா indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons. The HomeLinkா Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLinkா button that was just programmed. This procedure will not affect any other programmed HomeLinkா buttons. FCC Notice: For USA: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. For Canada: This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. IF YOUR VEHICLE IS STOLEN If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLinkா. Consult the Owner's Manual of each device or call the manufacturer or dealer of those devices for additional information. When your vehicle is recovered, you will need to reprogram the HomeLinkா Universal Transceiver with your new transmitter information. REPROGRAMMING A SINGLE HOMELINKா BUTTON To reprogram a HomeLinkா Universal Transceiver button, complete the following. 1. Press and hold the desired HomeLinkா button. Do not release the button until step 4 has been completed. 2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLinkா surface. 2-54 Instruments and controls
![](/manual_guide/autos/2012-nissan-altima-owners-manual-1d67673/132.png)