2013 Nissan Altima Owner's Manual - Page 120
2013 Nissan Altima Manual
Page 120 highlights
WARNING ● Do not use the HomeLinkா Universal Transceiver with any garage door opener that lacks safety stop and reverse features as required by federal safety standards. (These standards became effective for opener models manufactured after April 1, 1982). A garage door opener which cannot detect an object in the path of a closing garage door and then automatically stop and reverse, does not meet current federal safety standards. Using a garage door opener without these features increases the risk of serious injury or death. ● During the programming procedure your garage door or security gate will open and close (if the transmitter is within range). Make sure that people or objects are clear of the garage door, gate, etc. that you are programming. ● Your vehicle's engine should be turned off while programming the HomeLinkா Universal Transceiver. Do not breathe exhaust gases; they contain colorless and odorless carbon monoxide. Carbon monoxide is dangerous. It can cause unconsciousness or death. PROGRAMMING HOMELINKா If you have any questions or are having difficulty programming your HomeLinkா buttons, refer to the HomeLinkா web site at: www.homelink.com or call 1-800-355-3515. NOTE: It is also recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLinkா for quicker programming and accurate transmission of the radiofrequency. 1. Position the end of your hand-held transmitter 1-3 inches (5-14 cm) away from the HomeLinkா surface, keeping the HomeLinkா 1 in view. indicator light ᭺ LIC2365 2. Using both hands, simultaneously press and hold the desired HomeLinkா button and handheld transmitter button. DO NOT re1 lease until the HomeLinkா indicator light ᭺ flashes slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be released. (The rapid flashing indicates successful programming.) NOTE: Some devices may require you to replace Step 2 with the cycling procedure noted in the "Programing HomeLinkா for Canadian customers and gate openers" section. Instruments and controls 2-49