2013 Nissan Altima Owner's Manual - Page 122

press and hold the desired HomeLinkா button while you press and re-press ("cycle") your hand-held transmitter every two seconds until the frequency signal has been learned. The HomeLinkா indicator light will flash slowly and then rapidly after several seconds upon successful training. DO NOT release until the HomeLinkா indicator light flashes slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be released. The rapid flashing indicates successful training. Proceed with "Programming HomeLinkா" step 3 to complete. If the device was unplugged during the programming procedure, remember to plug it back in when programming is completed. PROGRAMMING TROUBLEDIAGNOSIS If the HomeLinkா does not quickly learn the handheld transmitter information: ● replace the hand-held transmitter batteries with new batteries. ● position the hand-held transmitter with its battery area facing away from the HomeLinkா surface. ● press and hold both the HomeLinkா and hand-held transmitter buttons without interruption. ● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLinkா surface. Hold the transmitter in that position for up to 15 seconds. If HomeLinkா is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times. If you have any questions or are having difficulty programming your HomeLinkா buttons, refer to the HomeLinkா web site at: www.homelink.com or call 1-800-355-3515. CLEARING THE PROGRAMMED INFORMATION The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed, see "Reprogramming a single HomeLinkா button" in this section. To clear all programming: 1. Press and hold the two outer HomeLinkா buttons until the indicator light begins to flash in approximately 10 seconds. Do not hold for longer than 20 seconds. 2. Release both buttons. HomeLinkா is now in the programming mode and can be programmed at any time beginning with "Programming HomeLinkா" - Step 1. OPERATING THE HOMELINKா UNIVERSAL TRANSCEIVER The HomeLinkா Universal Transceiver, after it is programmed, can be used to activate the programmed device. To operate, simply press and release the appropriate programmed HomeLinkா Universal Transceiver button. The amber indicator light will illuminate while the signal is being transmitted. For convenience, the hand-held transmitter of the device may also be used at any time. REPROGRAMMING A SINGLE HOMELINKா BUTTON To reprogram a HomeLinkா Universal Transceiver button, complete the following: 1. Press and hold the desired HomeLinkா button. DO NOT release the button. Instruments and controls 2-51