2013 Nissan Altima Owner's Manual - Page 206
2013 Nissan Altima Manual
Page 206 highlights
The FM stereo indicator STEREO will illuminate during FM stereo reception. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. XM band select: Press the XM button to change the band as follows: XM1* → XM2* → XM3* → XM1 (satellite, if so equipped) When the XM button is pressed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. The last station played will also come on when the VOL/ON·OFF control knob is pressed ON. *When the XM button is pressed, the satellite radio reception will not be available unless an optional satellite receiver and antenna are installed and a SiriusXM Satellite Radio service subscription is active. Satellite radio is not available in Alaska, Hawaii and Guam. If a compact disc is playing when the XM button is pressed, the compact disc will automatically be turned off and the last radio station played will come on. TUNE/FOLDER (Tuning) knob: To manually tune the radio, turn TUNE/FOLDER knob to the right or left. Seeking button: For AM or FM: side of the seeking button to Press the tune from high to low frequencies and stop at the side next broadcasting station. Press the of the seeking button to tune from low to high frequencies and stop at the next broadcasting station. For XM: or side of the seeking Press the button to go to the first channel of the previous or next category. 1 to 6 Station memory operations: Six stations can be set for the AM band. Twelve stations can be set for the FM band (6 for FM1, 6 for FM2). Eighteen channels can be set for the XM radio (6 for XM1, 6 for XM2, 6 for XM3 - if so equipped). 1. Choose the radio band AM, FM1 or FM2 using the FM·AM select button, or choose the satellite band XM1, XM2 or XM3 using the XM button. the 2. Tune to the desired station using seeking button. Press and the hold any of the desired station memory buttons (1 - 6) until the preset number is updated on the display and the sound is briefly muted. 3. The channel indicator will then come on and the sound will resume. Programming is now complete. 4. Other buttons can be set in the same manner. If the battery cable is disconnected, or if the fuse opens, the radio memory will be canceled. In that case, reset the desired stations. List (AM and FM) Select the "List" key to see a list of the presets in the AM, FM1 or FM2 preset banks. Monitor, climate, audio, phone and voice recognition systems 4-57