2013 Nissan Leaf Owner's Manual - Page 116

7. Check to make sure the child restraint is properly secured prior to each use. If the child restraint is loose, repeat steps 1 through 6. FORWARD-FACING CHILD RESTRAINT INSTALLATION USING THE SEAT BELTS WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a child in a sudden stop or collision. Also, it can change the operation of the front passenger air bag. See ؆Front passenger air bag and status lightЉ. Forward-facing - step 6 6. After attaching the child restraint, test it before you place the child in it. Push it from side to side while holding the child restraint near the LATCH attachment path. The child restraint should not move more than 1 inch (25 mm), from side to side. Try to tug it forward and check to see if the LATCH attachment holds the restraint in place. If the restraint is not secure, tighten the LATCH attachment as necessary, or put the restraint in another seat and test it again. You may need to try a different child restraint. Not all child restraints fit in all types of vehicles. Forward-facing (front passenger seat) - step 1 Refer to all Warnings and Cautions in "Child safety" and "Child restraints" earlier in this section before installing a child restraint. Follow these steps to install a forward-facing child restraint using the vehicle seat belt in the rear seat or in the front passenger seat: 1. If you must install a child restraint in the front seat, it should be placed in the forward-facing direction only. Move the seat to the rearmost position. Child restraints for infants must be used in the Safety-Seats, seat belts and supplemental restraint system 1-27