2013 Nissan Leaf Owner's Manual - Page 296
2013 Nissan Leaf Manual
Page 296 highlights
CAUTION • Do not slide the shift lever while pushing the P position switch. This may also damage the electric motor. • When switching to the preferred position by operating the shift lever, check that the shift lever returns to the central position by releasing your hand from the lever. Holding the shift lever in a mid-way position may also damage the shift control system. • Do not operate the shift lever while the accelerator pedal is depressed, except when switching to the ECO position. This may cause a sudden start which could result in an accident. • The following operations are not allowed because excessive force would be applied to the traction motor and this may result in damage to the vehicle: - Moving the shift lever to the R (Reverse) position when driving forward - Moving the shift lever to the D (Drive) or ECO position when reversing If these operations are attempted, a chime sounds and the vehicle shifts to the N (Neutral) position. apply the parking brake first while keeping the foot brake pedal depressed then push the P (Park) position switch and place the vehicle in the P (Park) position. See ЉParking brakeЉ. NOTE: • While the vehicle is stationary, if the shift position is placed in any position other than the P (Park) position when the power switch is set to OFF, it will automatically switch to the P (Park) position. • If the P (Park) position switch is pressed while sliding the shift lever, the shift position will not switch to the P (Park) position. When pressing the P (Park) position switch be sure to first allow the shift lever to return to its center position. R (Reverse): Use this position to back up. Make sure that the vehicle is completely stopped before selecting the R (Reverse) position. If the vehicle is placed in the D (Drive) position while reversing, the chime will sound and the vehicle will switch into the N (Neutral) position. P (Park): Use this shift position when the vehicle is parked or when placing the vehicle in the READY to drive position. Make sure that the vehicle is completely stopped. In order to switch to the P (Park) position, press the P (Park) position switch as shown in the illustration above once the vehicle has come to a complete stop. If the P (Park) position switch is pressed while the vehicle is in motion, a chime sounds and the current shift position is maintained. After switching to the P (Park) position, apply the parking brake. When parking on a hill, Starting and driving 5-13