2013 Nissan Titan Crew Cab Owner's Manual - Page 118

POWER INVERTER SWITCH (if so equipped) ● Use the E-Lock system only when freeing a stuck vehicle. Try the 4LO position before using the E-Lock system. Never use the E-Lock system on a slippery road surface such as snow or ice surface. Using the E-Lock system when driving in these road conditions may cause unexpected movement of the vehicle during engine braking, accelerating or turning, which may result in an accident and serious personal injury. CAUTION ● Use power outlets with the engine running to avoid discharging the vehicle battery. ● Do not attempt to use this while driving. ● Do not use double adapters or more than one electrical accessory, doing so could significantly drain the battery of your vehicle. CAUTION ● After using the E-Lock system, turn the switch OFF to prevent possible damage to driveline components from extended use. ● Do not drive over 12 MPH (20 km/h) when the system is engaged. Doing so could result in possible damage to the driveline. ● Do not turn on the E-lock system while the tires are spinning. Doing so could damage drivetrain components. LIC2075 To use the outlets for devices that require 120v power, place the ignition in the ON position and push the power inverter switch. The 400W or 150W on the switch will illuminate according to the mode selected. Only the 150W is available when the ignition switch is placed in the ON position or while the vehicle is being driven. For more information on using devices that require the power inverter switch activated, see "120v outlets" later in this section. Instruments and controls 2-37