2013 Nissan Titan Crew Cab Owner's Manual - Page 142

PROGRAMMING TROUBLEDIAGNOSIS If the HomeLinkா does not quickly learn the handheld transmitter information: ● replace the hand-held transmitter batteries with new batteries. ● position the hand-held transmitter with its battery area facing away from the HomeLinkா surface. ● press and hold both the HomeLinkா and hand-held transmitter buttons without interruption. ● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLinkா surface. Hold the transmitter in that position for up to 15 seconds. If HomeLinkா is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times. If you have any questions or are having difficulty programming your HomeLinkா buttons, refer to the HomeLinkா web site at: www.homelink.com or call 1-800-355-3515. CLEARING THE PROGRAMMED INFORMATION The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed, see "Reprogramming a single HomeLinkா button" in this section. To clear all programming: 1. Press and hold the two outer HomeLinkா buttons until the indicator light begins to flash in approximately 10 seconds. Do not hold for longer than 20 seconds. 2. Release both buttons. HomeLinkா is now in the programming mode and can be programmed at any time beginning with "Programming HomeLinkா" - Step 1. 2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLinkா button, proceed with "Programming HomeLinkா" - Step 1. For questions or comments, contact HomeLinkா at: www.homelink.com or 1-800-355-3515. The HomeLinkா Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLinkா button that was just programmed. This procedure will not affect any other programmed HomeLinkா buttons. IF YOUR VEHICLE IS STOLEN If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLinkா. Consult the Owner's Manual of each device or call the manufacturer or dealer of those devices for additional information. When your vehicle is recovered, you will need to reprogram the HomeLinkா Universal Transceiver with your new transmitter information. REPROGRAMMING A SINGLE HOMELINKா BUTTON To reprogram a HomeLinkா Universal Transceiver button, complete the following: 1. Press and hold the desired HomeLinkா button. DO NOT release the button. Instruments and controls 2-61