2014 Nissan Altima Owner's Manual - Page 182

REAR AND REAR-WIDE VIEW MONITOR WITH MOVING OBJECT DETECTION (MOD) (if so equipped) ● When strong light directly enters the camera, objects may not be displayed clearly. ● Vertical lines may be seen in objects on the screen. This is due to strong reflected light from the bumper. This is not a malfunction. ● The screen may flicker under fluorescent light. This is not a malfunction. ● The colors of objects on the RearView Monitor may differ somewhat from those of the actual object. ● When the contrast of objects is low at night, pressing the SETTING button or MENU button may not change the brightness. ● Objects on the monitor may not be clear in a dark place or at night. ● If dirt, rain or snow attaches to the camera, the RearView Monitor may not display objects. Clean the camera. ● Do not use body wax on the camera window. If body wax does get on the camera window, wipe off the wax with a clean cloth dampened with mild detergent diluted with water. When the shift lever is shifted into the R (Reverse) position, the monitor display shows view to the rear of the vehicle. The system is designed as an aid to the driver in detecting large stationary objects to help avoid damaging the vehicle. The system will not detect small objects below the bumber and may not detect objects close to the bumper or on the ground. Available views: ● Rear View An approximately 150-degree view of the rear of the vehicle. ● Rear-Wide View An approximately 180-degree view of the rear of the vehicle. ● Objects viewed in the RearView Monitor differ from actual distance because a wide-angle lens is used. Objects viewed in the RearView Monitor appear visually opposite, just like ones viewed in the inside and outside rearview mirrors. ● Make sure that the trunk is securely closed when backing up. ● Underneath the bumper and the corner areas of the bumper cannot be viewed on the RearView Monitor because of its monitoring range limitation. ● Do not put anything on the RearView camera. The RearView camera is installed above the license plate. ● When washing the vehicle with highpressure water, be sure not to spray it around the camera. Otherwise, water may enter the camera unit causing water condensation on the lens, a malfunction, fire or an electric shock. ● Do not strike the camera. It is a precision instrument. Otherwise, it may malfunction or cause damage resulting in a fire or an electric shock. WARNING ● The RearView Monitor is a convenience but it is not a substitute for proper backing up. Always turn and check that it is safe to do so before backing up. Always back up slowly. Monitor, climate, audio, phone and voice recognition systems 4-13