2015 Nissan Armada Owner's Manual - Page 259

XM band select Press the XM button to change the band as follows: XM1* → XM2* → XM3* → XM1* When the XM button is pressed with the ignition switch in the ACC or ON position, the radio will come on at the station last played. The last station played will also come on when the ON·OFF button is pressed ON. *When the XM button is pressed, the satellite radio mode will not be available unless an optional satellite receiver and antenna are installed and a SiriusXM® Satellite Radio service subscription is active. Satellite radio is not available in Alaska, Hawaii and Guam. If a compact disc is playing when the XM button is pressed, the compact disc will automatically be turned off and the last radio station played will come on. Manual tuning To manually tune the radio, turn the TUNE/FLDR TUNE knob to the right or left or use the buttons. and FLDR SEEK/CAT and TRACK tuning buttons For AM or FM: button or the Press the SEEK/CAT button to tune from high to low or TRACK low to high frequencies and stop at the next broadcasting station. For XM: button or the Press the SEEK/CAT button to go to the first channel of TRACK the previous or next category. SCAN tuning Press the SCAN button to stop at each broadcasting station for 5 seconds. Pressing the SCAN button again during this 5 second period will stop scan tuning and the radio will remain tuned to that station. If the SCAN button is not pressed within 5 seconds, scan tuning moves to the next station. 1 to 6 Station memory operations Six stations can be set for the AM band. Twelve stations can be set for the FM band (six for FM1, six for FM2). Eighteen channels can be set for the SAT radio (six for XM1, six for XM2, six for XM3 - if so equipped). 1. Choose the radio band AM, FM1 or FM2 using the FM·AM select button, or choose the satellite band XM1, XM2 or XM3 using the SAT button. 2. Tune to the desired station using manual, SEEK or SCAN tuning. Press and hold any of the desired station memory buttons (1 - 6) until the preset number is updated on the display and the sound is briefly muted. 3. The channel indicator will then come on and the sound will resume. Programming is now complete. 4. Other buttons can be set in the same manner. If the battery cable is disconnected, or if the fuse opens, the radio memory will be canceled. In that case, reset the desired stations. List (AM and FM) Select the "List" key using the NISSAN controller or touch-screen to see a list of the presets in the AM, FM1 or FM2 preset banks. 4-58 Monitor, climate, audio, phone and voice recognition systems