2015 Nissan Xterra Owner's Manual - Page 237
2015 Nissan Xterra Manual
Page 237 highlights
● You will not be able to use a hands-free phone under the following conditions: - Your vehicle is outside of the cellular service area. - Your vehicle is in an area where it is difficult to receive cellular signal; such as in a tunnel, in an underground parking garage, near a tall building or in a mountainous area. - Your cellular phone is locked to prevent it from being dialed. ● When the radio wave condition is not ideal or ambient sound is too loud, it may be difficult to hear the other person's voice during a call. ● Immediately after the ignition switch is placed in the ON position, it may be impossible to receive a call for a short period of time. ● Do not place the cellular phone in an area surrounded by metal or far away from the in-vehicle phone module to prevent tone quality degradation and wireless connection disruption. ● While a cellular phone is connected through the Bluetooth® wireless connection, the battery power of the cellular phone may discharge quicker than usual. The Bluetooth® Hands-Free Phone System cannot charge cellular phones. ● If the hands-free phone system seems to be malfunctioning, refer to "Troubleshooting guide" in this section. You can also visit www.nissanusa.com/bluetooth for troubleshooting help. ● Some cellular phones or other devices may cause interference or a buzzing noise to come from the audio system speakers. Storing the device in a different location may reduce or eliminate the noise. ● Refer to the cellular phone owner's manual regarding the telephone charges, cellular phone antenna and body, etc. ● The signal strength display on the monitor will not coincide with the signal strength display of some cellular phones. REGULATORY INFORMATION FCC Regulatory information - CAUTION: To maintain compliance with FCC's RF exposure guidelines, use only the supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations. - Operation is subject to the following two conditions: 1. This device may not cause interference and 2. this device must accept any interference, including interference that may cause undesired operation of the device. IC Regulatory information - Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. - This Class B digital apparatus meets all requirements of the Canadian InterferenceCausing Equipment Regulations. 4-86 Monitor, climate, audio, phone and voice recognition systems