2002 Polaris Sportsman 6x6 Owners Manual - Page 55

OPERATION Starting a Cold Engine 1. Place the transmission in neutral and reset the parking brake. 2. Turn the fuel tank valve to ON. 3. Sit on the vehicle. 4. Pull the choke button (A) all the way out. 5. Set the engine stop switch to "run". 6. Turn the ignition key past the "ON" position to engage the starter. A NOTE: the choke is on "FULL" when the knob is pulled out all the way. The choke is "OFF" when the knob is pushed in. This is a variable choke and can be adjusted gradually, depending on how much choke is needed for starting. 7. Do not press the throttle while starting the engine. 8. Activate the starter for a maximum of five seconds, releasing the key or button when the vehicle starts. If engine does not start, release the starter and wait five seconds; then activate the starter for another five seconds. Repeat this procedure until engine starts. NOTE: Do not press the throttle while starting the engine. After the Engine Starts 1. If the engine slows or stops, pushing the choke button in half way will allow proper engine warm up. 2. Vary the engine RPM slightly with the throttle to aid in warm up until the engine idles smoothly. Then push the choke button all the way in. Proper engine warm up is essential each time before driving to avoid engine damage. CAUTION WARNING Carbon monoxide exhaust gas is poisonous! Always start the vehicle outdoors. Never run the engine in an enclosed area. 52