2008 Polaris Sportsman 6x6 Owners Manual - Page 81
2008 Polaris Sportsman 6x6 Manual
Page 81 highlights
MAINTENANCE Oil and Filter Change CAUTION Hot oil can cause serious burns to skin. Do not allow hot oil to contact skin. If the ATV is left without oil in the system for extended periods, the oil pump may lose its prime, which could result in engine damage. Always replace the oil and filter within a few hours of draining the oil. Do not allow the vehicle to be without oil overnight. Always change the oil and filter at the intervals outlined in the Periodic Maintenance Chart beginning on page 70. Always change the oil filter whenever changing oil. 1. Position the vehicle on a level surface. 2. Start the engine. Allow it to idle for two to three minutes. Stop the engine. Screen 3. Clean the area around the Fitting drain plug. Drain Plug 4. Place a drain pan under the oil tank. Remove the drain plug. Allow the oil to drain completely. New Sealing Washer 5. Install a new sealing washer on the drain plug. NOTE: The sealing surfaces on drain plug and crankcase should be clean and free of burrs, nicks or scratches. 6. Reinstall the drain plug. Torque to 14-17 ft. lbs. (19-23 Nm). 7. Disconnect the lower oil delivery hose and remove the screen fitting from the oil tank. Clean the fitting. seal tape. Alignment Mark NOTE: The fitting threads must be sealed with LOCTITE PST 505 or PTFE 78