1995 Pontiac Trans Sport Owner's Manual - Page 120
1995 Pontiac Trans Sport Manual
Page 120 highlights
Here's the second way to go to ahigher speed: Move the cruise switch from ON to WA. Hold it there until you get up to the speed you want, and then release the switch. Passing Another Vehicle While Using Cruise Control Use the accelerator pedal to increase your speed. When you take your foot off the pedal,your vehicle will slow down to the cruisecontrol speed you set earlier. To increase your speed in very small amounts, move the switch to R/A for lessthan half a second and then release it. Each time you do this, your vehicle will go about 1 mph (1.6 km/h) faster. If you have the 3.1L V6 engine, the accelerate feature will work whether or not you have set an initial cruise control speed. Using Cruise Control on Hills How well your cruise control will work on depends hills upon your speed, load, andthe steepness of the hills. When going up steep hills, you may have to step on the accelerator pedal to maintain your speed. When going downhill, you may have to brake or shift to alower gear to keep your speed down.Of course, applying the brake takes you out of cruise control. Many drivers find to be too this much trouble and don't use cruisecontrol on steep hills. If you have the 3800 V6 engine, the accelerate feature will only work after you have set the initial cruise control speed by pushing the SET button. To Reduce Speed While Using Cruise Control 0 To Get Out of Cruise Control There are two ways to turn off the cruise control: Step lightly on the brake pedal; OR Move the cruise switch to OFF. Push in the button at the end of the lever until you reach the lower speed you want, then release it. To slow down in very small amounts, push the button for lessthan half a second. Each time you do this, you'11 go 1 mph (1.6 k k slower. m) To Erase Speed Memory When you turn o f the cruise control or the ignition, your f cruise control set speed memory is erased. If you have the 3800 V6 engine, cruise control memory will also be erased when you place the transaxle PARK (P). in 2-49