2009 Saab 9-3 Owner's Manual - Page 91
2009 Saab 9-3 Manual
Page 91 highlights
93_US_MY09.book Page 91 Tuesday, April 15, 2008 10:30 AM Instruments and controls When the engine is started, the function that was selected when the engine was switched off is displayed, with the following exceptions: • Temp is displayed if the outside temperature is between 26 and 38°F (-3 and +3°C). • D.T.E. is displayed if less than or equal to 30 miles (50 km). Outdoor temperature Setting values 1 Select one of the functions using the steering wheel controls, or . • Dist (preset to 100 miles (100 km) if not previously set) • Speed Ø • Speed W (preset to 55 mph (90 km/h). 2 Press and hold the SET button until given audible confirmation. 3 Use the steering wheel controls to select the value. (Press CLR to reset the value.) 4 Press the SET button to finish setup. Using DIST as a trip meter 1 Select Dist using the steering wheel controls, or . 2 Press and hold the CLR button for approx. 1 second. An arrow will now appear on the right-hand side of the display, indicating that the trip meter is running. Resetting a single function 91 1 Select the function you wish to reset using the steering wheel controls, or . • Fuel Ø • Speed Ø • Trip (Dist used as trip meter). 2 Press and hold the CLR button for approx. 1 second. The selected function will now be reset. WARNING Remember that roads can be icy even at temperatures of above 38°F (+3°C), especially on bridges and stretches of road that are sheltered from the sun. The Temp function is always activated (even in NIGHTPANEL mode) if the outdoor temperature rises or falls to between 26 and 38 °F (-3 and +3 °C). If the temperature sensor, located under the front bumper, is covered by snow or ice, temperature readings will be unreliable.