2009 Saab 9-3 Owner's Manual - Page 99

93_US_MY09.book Page 99 Tuesday, April 15, 2008 10:30 AM Instruments and controls Courtesy Headlamp Feature 99 A delay function allows the low beam headlights and back-up lights to remain on for about 30 seconds after the driver's door has been closed. To activate this function: 1 After turning off the engine, remove the remote control. 2 Open the driver's door. 3 Pull the control stalk all the way towards the steering wheel. Xenon cornering headlights 3 When the car speed exceeds approx. 6 mph (10 km/h), the main headlight will be angled when the steering wheel is turned. The beam can be angled maximum 15 ° to the right or left compared to a car without cornering headlights. If a fault occurs in the cornering headlights, there is no angling when the steering wheel is turned. The beam continues to shine straight ahead and the following message appears in SID: Cornering headlights malfunction Dimmer switch 1 Headlight flasher 2 High/low beam The low beam headlights and reversing lights will come on and remain on for 30 seconds when the door is closed. High/low beam To switch between high and low beam, pull the control stalk all the way towards the steering wheel. (Headlight switch must be ON.) The symbol on the main instrument panel shows when the high beam is on. Headlight flasher To flash your headlights, pull the control stalk half-way towards the steering wheel. The high beam will remain on until you release the stalk.