2008 Saturn Outlook Owner's Manual - Page 394
2008 Saturn Outlook Manual
Page 394 highlights
9. Push the On/Off button (B). The tire sealant and compressor kit will inject sealant and air into the tire. Sealant may leak from the puncture until the vehicle is driven and the hole has sealed. The pressure gage (C) will initially show a high pressure while the compressor pushes the sealant into the tire. Once the sealant is completely dispersed into the tire, the pressure will quickly drop and start to rise again as the tire inflates with air only. 10. Inflate the tire to the recommended inflation pressure using the air pressure gage (E) on the top of the unit. The recommended inflation pressure can be found on the Tire and Loading Information label. See Inflation - Tire Pressure on page 5-56. The pressure gage reading is slightly high while the compressor is on. Turn the compressor off to get an accurate reading. The compressor may be turned on and off until the correct pressure is reached. Notice: If the recommended pressure cannot be reached after 20 minutes, the vehicle should not be driven farther. Damage to the tire is severe and the sealant will not be effective. Remove the air compressor plug from the accessory power outlet and unscrew the inflating hose from the tire valve. See Roadside Assistance Program on page 7-7 for more information. 11. Turn the compressor off by pushing the On/Off switch (B). Steps 12 through 20 must be done immediately after Step 11. The tire is not sealed and will continue to leak air until the vehicle is driven and the sealant is distributed in the tire. Be careful while handling the tire sealant and compressor kit as they could be hot after usage. 12. Unplug the air compressor accessory plug (E) from the accessory power outlet in the vehicle. 13. Disconnect the sealant/air hose (F) from the tire valve stem by turning it counterclockwise and replace the tire valve stem cap. 14. Wrap the sealant/air hose (F) around the air compressor channel to stow it in its original location. 15. Stow the air compressor accessory plug (E) back into place. 5-78