3Com 3CR858-91 User Guide - Page 15
Power LED, Four LAN Status LEDs, Cable/DSL Status LED - problem
UPC - 662705490946
View all 3Com 3CR858-91 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Front Panel 15 In each of these cases, wait until the Router has completed the current operation and the alert LED is Off. Flashing slowly - The Router has completed the Reset to Factory Defaults process, and is waiting for you to reset the unit. To do this, remove power, wait 10 seconds and then re-apply power. The Router will then enter the start-up sequence and resume normal operation. If you have used a cable to reset the unit to Factory Defaults, refer to "Forgotten Password and Reset to Factory Defaults" on page 93. On for 2 seconds, and then off - The Router has detected and prevented a hacker from attacking your network from the Internet. Continuously on - A fault has been detected with your Router during the start-up process. Refer to Chapter 6 "Troubleshooting". 2 Power LED Green Indicates that the Router is powered on. 3 Four LAN Status LEDs Green (100Mbps link) / yellow (10Mbps link) If the LED is on, the link between the port and the next piece of network equipment is OK. If the LED is flashing, the link is OK and data is being transmitted or received. If the LED is off, nothing is connected, the connected device is switched off, or there is a problem with the connection (refer to Chapter 6 "Troubleshooting"). The port will automatically adjust to the correct speed and duplex. 4 Cable/DSL Status LED Green (100Mbps link) / yellow (10Mbps link) If the LED is on, the link between the Router and the cable or DSL modem is OK. If the LED is flashing, the link is OK and data is being transmitted or received. If the LED is off, nothing is connected, the modem is switched off or there is a problem (refer to Chapter 6 "Troubleshooting").