3M MP8640 Operation Guide - Page 25
When You Think Something Is Wrong
UPC - 051125589963
View all 3M MP8640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
6.3.3 Remove lamp module: Grasp the lamp module with the one hand and the projector body opening with the other hand. Apply pressure to the projector body as you slide the lamp out. 6.3.4 Insert lamp module: Carefully insert the new lamp module. Ensure that it is fully seated. Tighten the lamp module retaining screws to secure the lamp module in place. Insert the hinge tabs on the left side of the lamp access door, then close and tighten the retaining screws to secure the door. 6.4 When You Think Something Is Wrong Check the following table before asking for service. If a solution cannot be found, consult dealer. Symptom Cause Solution Power cannot be turned • The Main power is not turned on. on. • The power cord is disconnected. • Turn the MAIN POWER switch on. • Insert the power cord into an AC socket. No picture and sound • The setting of the input source is not correct. • Set the correct input using the input select button of the projector or the remote control. •RGB/Video/Audio wiring to projector is • Connect the cable correctly. not correct. Sound is heard with no picture • Connect the cable correctly. • RGB/Video wiring to projector is not correct. • Press the MENU button and increase • The brightness is set fully to dark. BRIGHTNESS. Picture is displayed with no sound • Audio wiring to projector is not correct. • The volume is set to minimum. • The unit is muted. • Connect the cable correctly. • Press the VOL button and increase VOLUME. • Press the MUTE button. Color is weak and tint is • The color and tint have been adjusted incorrect incorrectly. • Adjust the color and tint correctly. Picture is dark • The brightness and contrast has been adjusted incorrectly. • The lamp needs to be replaced. • Adjust the brightness and contrast correctly. • Replace the lamp with a new one. Picture is not clear • Projector is out of focus. • Adjust the focus. LAMP indicator lights red. • Lamp will not ignite. • Turn off power and let cool for 20 minutes, then restart. • If problem persists call your dealer. TEMP indicator lights red. LAMP indicator blinks red. • Temperature inside projector is too hot. • Do not block the ventilation holes. • Clean air filter • Air filter door on bottom of case is open. • Ensure air filter door is closed. © 3M 1997 3M™ Multimedia Projector MP8640 25