AEG BP5304001W Product Manual - Page 28
Warning
View all AEG BP5304001W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
28 What to do if... 2. Hold the door t (B) on the top edge of the door at the two sides and push inwards to release the clip seal. 3. Pull the door t to the front to remove it. B 4. Hold the door glass panels on their top edge one by one and pull them up out of the guide 5. Clean the door glass panels. To install panels follow the procedure in reverse. Install the smaller panel first, then the larger. WHAT TO DO IF... WARNING! Refer to "Safety information" chapter. Problem Possible cause Solution The oven does not heat up The appliance is switched off Switch on the appliance The oven does not heat up The clock is not set Set the clock. Refer to "Setting the clock" The oven does not heat up The necessary settings are not Make sure, the settings are cor- set rect The oven does not heat up The automatic cut-out is switched on Refer to „Automatic cut-out" The oven does not heat up The fuse is released Make sure, if the fuse is the cause for the malfunction. If the fuse releases again and again, refer to an authorized electrician The oven lamp does not operate The oven lamp is defective Replace the oven lamp. The pyrolytic cleaning does not The shelf runners/telescopic Remove side rails/oven shelf operate (the clock display shelf runners are not removed runners shows „C1") The pyrolytic cleaning does not The door is not correctly closed Close the door correctly operate (the time display shows or door lock is defective „C3")