AEG KSK782220M User Manual - Page 52
Problem, Possible cause, Remedy
View all AEG KSK782220M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
52 www.aeg.com Problem Possible cause Remedy The display shows an error There is an electrical fault. code that is not in this table. • Deactivate the oven with the house fuse or the safety switch in the fuse box and activate it again. • If the display shows the error code again, contact the Customer Care Department. Steam and condensation You left the dish in the oven settle on the food and in the for too long. cavity of the oven. Do not leave the dishes in the oven for longer than 15 20 minutes after the cooking process ends. The appliance is activated and does not heat up. The fan does not operate. The display shows "Demo". The demo mode is activated. Refer to "Basic Settings" in "Daily use" chapter. The descaling procedure is There was a power cut. interrupted before it finishes. Repeat the procedure. The descaling procedure is The function was stopped by Repeat the procedure. interrupted before it finishes. the user. There is no water inside the grill- / roasting pan after the descaling procedure. You did not fill the water drawer to the maximum level. Check if the a descaling agent / water is present in the water drawer body. Repeat the procedure. There is dirty water on the bottom of the cavity after the descaling cycle. The grill- / roasting pan is on Remove the residual water a wrong shelf position. and the descaling agent from the bottom of the oven. Put the grill- / roasting pan on the first shelf posi- tion. The cleaning function is in- There was a power cut. terrupted before it finishes. Repeat the procedure. The cleaning function is in- The function was stopped by Repeat the procedure. terrupted before it finishes. the user. There is too much water on the bottom of the cavity after the end of the cleaning function. You sprayed too much detergent in the appliance before the activation of the cleaning cycle. Cover all parts of the cavity with a thin layer of the detergent. Spray the detergent evenly. There is no good performance of the cleaning procedure. The initial oven cavity tem- Repeat the cycle. Run the cyperature of the steam clean- cle when the appliance is ing function was too high. cold.