AIWA CSD-ES227 Operating Instructions - Page 3
Power Supply
View all AIWA CSD-ES227 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Power Supply FUNCTION OPE/BATT IMPORTANT Make sure that FUNCTION is set to (!) STANDBY POWER/ TAPE before connecting the AC cord or inserting batteries. Connect the AC cord as illustrated below. 'l~ to the AC inlet of the unit =+@ to an AC outlet CAUTION Use only the supplied AC cord. Use with other cords may result in the risk of fire. Open the lid of the battery compartment on the rear and insert eight R14 (size C) batteries, not supplied, with the 0 and O marks correctly aligned. Then close the lid, To switch from AC power supply to battery power supply, disconnect the AC cord from the AC inlet. The batteries need to be replaced when: The OPE/BATT indicator becomes dim, the tape speed slows down, volume decreases, or sound is distorted during operation. Notes on batteries q Do not mix different types of batteries or old batteries with new ones. q Never recharge the batteries, apply heat to them or take them apart. q Remove dead batteries. if liquid leaks from the batteries, wipe thoroughly to remove. Maintenance To clean the cabinet Use a soft cloth lightly moistened with mild detergent solution, Do not use strona solvents such as alcohol, benzine or thinner. - To clean the heads and tape paths After every 10 hours of use, clean the heads 0 and 0, the pinchroller 0 and capstan 0. Use a cotton swab @ slightly moistened with cleaning fluid or denatured alcohol. To clean the lens Lens Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the center to the edge. ENGLISH 3