AIWA NSX-V9000 Operating Instructions - Page 24

Troubleshooting, Guide, Parts Index

Get AIWA NSX-V9000 PDF manuals and user guides View all AIWA NSX-V9000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

TROUBLESHOOTING GUIDE PARTS INDEX If the unit fails to perform as described in these Operating Instructions, check the following guide. GENERAL There is no sound. q Is the AC cord connected properly? q Is there a bad connection? (+ page 3) q There may be a shofl, circuit in the speaker terminals. + Disconnect the AC cord, then correct the speaker connections. q Was an incorrect function button pressed? Sound is emitted from one speaker only. q Is the other speaker disconnected? The output sound is not stereo. q Is the Karaoke function turned on? (+ page 17) An erroneous display or a malfunction occurs. + Reset the unit as stated below. TUNER SECTION There is constant, wave-like static. q Is the antenna connected properly? (+ page 3) q Is the signal weak? + Connect an outdoor antenna. The reception contains noise interferences or the sound is distorted. q Is the system picking up external noise or multipath distortion? + Change the orientation of the antenna. + Move the unit away from other electrical appliances. CASSETTE DECK SECTION The tape does not run. q Is deck 2 in pause mode? (+ page 11) The sound is off-balance or not adequately high. q Is the playback head dirty? (+ page 21) Recording is not possible. q Is the erasure prevention tab on the tape broken off? (+ page 12) q Is the recording head dirty? (+ page 21) Erasure is not possible. q Is the erasure head dirty? (+ page 21) q Is a metal tape being used? High frequency sound is not emitted. q Is a tape recorded without Dolby NR played back with the Dolby NR system operating? (+ page 11) q Is the recording/playback head dirty? (+ page 21) CD PLAYER SECTION The CD player does not play. * Is the disc correctly inserted? (+ page 9) q Is the disc dirty? (+ page 21) q Is the lens affected by condensation? + Wait approximately one hour and try again. Instructions about each part on the main unit or remote control are indicated on the pages listed below. (in alphabetic order) Parts BBE % EDIT/CHECK (EDIT/CHECK) W CLEAR CLOCK DEMO DIGITAL ECHO +> DIRECTION/PRESET DISC CHANGE DISC DIRECT PLAY DOLBY NR

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
TROUBLESHOOTING
GUIDE
PARTS INDEX
If the unit fails
to perform
as described
in these
Operating
Instructions,
check the following guide.
GENERAL
There
is no sound.
Is the AC cord connected
properly?
Is there a bad connection?
(+
page 3)
There may be a shofl, circuit in the speaker terminals.
+
Disconnect
the
AC
cord,
then
correct
the
speaker
connections.
Was an incorrect function button pressed?
Sound
is emitted
from one speaker
only.
Is the other speaker disconnected?
The output
sound
is not stereo.
Is the Karaoke function turned on? (+ page 17)
An erroneous
display
or a malfunction
occurs.
+
Reset the unit as stated below.
TUNER
SECTION
There
is constant,
wave-like
static.
Is
the antenna connected
properly? (+
page 3)
Is the signal weak?
+
Connect an outdoor antenna.
The reception
contains
noise interferences
or the sound
is distorted.
Is
the system picking up external noise or multipath distortion?
+
Change the orientation of the antenna.
+
Move the unit away from other electrical appliances.
CASSETTE
DECK SECTION
The tape does not run.
Is deck 2 in pause mode? (+
page 11)
The sound
is off-balance
or not adequately
high.
Is the playback head dirty? (+ page 21)
Recording
is not possible.
Is the erasure prevention tab on the tape broken off? (+
page
12)
Is the recording head dirty? (+ page 21)
Erasure
is not
possible.
Is the erasure head dirty? (+
page 21)
Is a metal tape being used?
High frequency
sound
is not emitted.
Is
a tape recorded without Dolby NR played back with the Dolby
NR system operating?
(+ page 11)
Is the recording/playback
head dirty? (+ page 21)
CD PLAYER
SECTION
The CD player
does not play.
*
Is the disc correctly inserted? (+
page 9)
Is the disc dirty? (+
page 21)
Is the lens affected by condensation?
+
Wait approximately
one hour and try again.
To reset
Instructions
about each part on the main unit or remote control
are indicated on the pages listed below.
(in alphabetic order)
Parts
Pages
BBE
6
9
%
EDIT/CHECK
(EDIT/CHECK)
9, 15, 16
W CLEAR
8,9,11
CLOCK
5
DEMO
5
DIGITAL ECHO
17
+>
DIRECTION/PRESET
8, 9, 11
DISC CHANGE
9
DISC DIRECT PLAY
9
DOLBY NR
12
<<,
1<< DOWN
7,9,11
EDIT/CHECK
(CD EDIT/CHECK)
9, 15, 16
SURROUND
7
GEQ
6
KARAOKE
(VOCAL FADEIWMULTIPLEX)
17
KARAOKE
ENTER
18
MIC 1, MIC2
17
MIC MIXING
17
A opEN/CLOSE
9
PHONES
6
POWER
5
PRGM
10
RANDOM
10
(0/0)
REC/REC MUTE
13
REPEAT/MONO
TUNER
7,”10
REV MODE (DECK 2)
11
II
SET
8, 9
SLEEP
20
SYNC DUB NORMAIJHIGH
14
TAPE/DECK
1/2
11, 13
T-BASS
6
TIMER
19
TUNE FVBAND
7
>1,
>
UP
7,9,11
VI DEO/AUX
21
VOCAL FADEWMULTIPLEX
(KARAOKE)
17
VOLUME
6
0-9, +10
10
If an unusual
condition
occurs
in the display
window
or the
cassette decks, reset the unit as follows.
1
Press the POWER button to turn off the power.
2
Press the POWER button to turn the power back on while
pressing the
CLEAR button. Everything stored in memory
after purchase is canceled.
If the power cannot be turned off in step 1 because of a malfunction,
reset by disconnecting the AC cord and repeat step 2.
23
ENGLISH