ASRock ConRoe1333-eSATA2 Quick Installation Guide - Page 20
These four Serial ATA II
View all ASRock ConRoe1333-eSATA2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
FDD connector (33-pin FLOPPY1) (see p.2 No. 26) the red-striped side to Pin1 Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Primary IDE connector (Blue) (39-pin IDE1, see p.2 No. 16) connect the blue end connect the black end to the motherboard to the IDE devices 80-conductor ATA 66/100 cable Note: Please refer to the instruction of your IDE device vendor for the details. Serial ATA II Connectors (SATAII_BLUE (PORT0): see p.2, No. 19) (SATAII_BLACK (PORT1): see p.2, No. 17) (SATAII_RED (PORT2): see p.2, No. 21) (SATAII_ORANGE (PORT3): see p.2, No. 15) SATAII_ORANGE (PORT3) SATAII_RED (PORT2) SATAII_BLACK (PORT1) SATAII_BLUE (PORT0) These four Serial ATA II (SATAII) connectors support SATA data cables for internal storage devices. The current SATA II interface allows up to 3.0 Gb/s data transfer rate. SATAII_RED (PORT2) and SATAII_ORANGE (PORT3) connectors can be used for internal storage devices or be connected to eSATAII_BOTTOM and eSATAII_TOP connectors with corresponding color to support eSATAII devices. Please read "eSATAII Interface Introduction" on page 26 for details about eSATAII and eSATAII installation procedures. eSATA II Connectors (eSATAII_TOP: see p.2, No. 37) (eSATAII_BOTTOM: see p.2, No. 36) eSATAII_TOP eSATAII_BOTTOM These two eSATA II connectors support SATA data cables for external SATAII function. The current eSATA II interface allows up to 3.0 Gb/s data transfer rate. Serial ATA (SATA) Either end of the SATA data cable Data Cable can be connected to the SATA / (Optional) SATAII hard disk or the SATAII connector on the motherboard. You can also use the SATA data cable to connect SATAII connec- tors and eSATAII connectors with corresponding color. 20 ASRock ConRoe1333-eSATA2 Motherboard English