Aastra OpenCom 131 User Guide - Page 28
Declarations of Conformity, 3.4 Mounting Location
View all Aastra OpenCom 131 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Installation Declarations of Conformity Do not allow any fluid to penetrate the OpenCom 100, because this may cause electric shocks or short circuits. Do not install the OpenCom 100 during a storm. Do not connect or disconnect lines during a storm. The OpenCom 100 is designed for indoor use only. Lay the cables so that they cannot be walked on or tripped over. The connection of external devices to the sensor/actor should be performed by a qualified electrician. 3.3 Declarations of Conformity The OpenCom 130, OpenCom 131 and OpenCom 150 ITC systems conform to the requirements set down in the EU directive 99/5/EC. The Declaration of Conformity can be viewed at the Aastra Web site at http://www.aastra.de or http://www.aastra.com. 3.4 Mounting Location The ambient temperature for operating the OpenCom 100 must be between +5 and +40°C. The power supply must be 230 V/50 Hz AC. A separate fuse for the power supply is recommended. To maintain the prescribed ambient temperature, mount the OpenCom 100 in a well-ventilated location, away from direct sources of heat. Do not position the OpenCom 100 ■ in front of or above heat sources such as radiators, ■ in direct sunlight, ■ behind curtains, ■ in small, unventilated, damp rooms, ■ on or near inflammable materials, ■ or near high-frequency devices such as transmitters, X-ray or similar apparatus. Use a separate 230 V power circuit and install overvoltage protection. 26