Aastra OpenCom 131 User Guide - Page 39
Available Ports, 3.8.1 OpenCom 130, Phone no., Apply
View all Aastra OpenCom 131 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Installation Available Ports Previously assigned access numbers are displayed in the list. The list also displays the access numbers of the a/b ports you have configured. 2. In the Phone no. column, click the entry you wish to assign internal call numbers to. 3. Enter up to ten internal call numbers to which incoming external calls are to be signalled. 4. Click on the Apply button. 5. Repeat steps 2 to 4 until all allocations have been set in the call distribution. 3.8 Available Ports The OpenCom 100 has the following ports (see also Positions of the Ports starting on page 41): 3.8.1 OpenCom 130 The listed interfaces and ports are located on the basic module of the OpenCom 130. Further interfaces and ports can be added by installing the expansion set and additional interface cards (see Installing an Expansion Set starting on page 27 and Installing Interface Cards starting on page 30). ■ One S0 port to connect to an external S0 bus (usually the NTBA), designed as an RJ45 jack (S01) ■ One switchable S0 port (S02), which can be connected as either an internal or external S0 bus. The internal connection is via a pressure terminal and the external connection via an RJ45 jack. ■ Three Upn ports, designed as pressure terminals (Upn1 to Upn3) ■ Four analogue a/b ports, designed as pressure terminals (a/b1 to a/b4) ■ One slot to incorporate a doorstation equipment interface card. The following ports can be used with such a card: 37