Home » Acer Manuals » Desktops » Acer Aspire SA80 » Manual Viewer

Acer Aspire SA80 Aspire SA80 and Power S280 Service Guide - Page 75

Standard Disassembly Procedure, Opening the System, Removing the Front Panel

Add to My Manuals
Save this manual to your list of manuals

Page 75 highlights

Standard Disassembly Procedure This section tells you how to disassemble the system when you need to perform system service. The difference between Aspire SA80/AcerPower S280 is the outlooking but the inner disassembly and reassembly mechanic are the same. Before you proceed, make sure you have turned off the system and all peripherals connected to it. Opening the System 1. Place the system unit on a flat, steady surface. 2. Turn the housing back, and remove the four screws as shown here. 3. Slide the side door out. Then remove them. Removing the Front Panel 1. Press fastener as red arrowhead shown, then remove the front panel as shown. Removing the Cables from Mainboard 1. Disconnect the LCE instruction cable from mainboard. Chapter 3 67

Section	Page
S.G_Aspire SA80 & AcerPower S280_BOOK	1
Revision History	2
Copyright	3
Disclaimer	3
Conventions	4
Preface	5
T.O.C	6
S.G_Aspire SA80 & AcerPower S280_CH1	9
System Specifications	9
Overview	9
Features	10
Mainboard Placement	13
Block Diagram	15
Aspire SA80 Front Panel	16
Aspire SA80 Rear Panel	17
AcerPower S280 Front Panel	18
AcerPower S280 Rear Panel	19
System Peripherals	20
Mouse (PS/2 or USB, manufacturing option)	20
Keyboard (PS/2 or USB, manufacturing option)	20
Speakers	21
Acer eRecovery	22
Create backup	22
Restore from backup	22
Create factory default image CD	22
Re-install bundled software without CD	23
Change Password	23
Acer disc-to-disc recovery	24
Restore without a Recovery CD	24
Multilingual operating system installation	24
Hardware Specifications and Configurations	25
Power Management Function (ACPI support function)	30
Jumper Setting	31
Setting Jumper	31
Checking Jumper	32
Checking Connector	33
S.G_Aspire SA80 & AcerPower S280_CH2	43
System Utilities	43
Entering Setup	44
Product Information	46
Standard CMOS Features	47
Advanced BIOS Features	49
CPU Features	51
Hard Disk Boot Priority	52
Advanced Chipset Features	53
DRAM Clock/Timing Control	54
AGP & P2P Bridge Control	55
Onchip AGP Control	56
Integrated Peripherals	57
SIS OnChip IDE Device	58
SIS OnChip PCI Device	59
Onboard Super IO Device	60
Power Management Setup	61
PM Wake Up Events	63
PnP/ PCI Configurations	65
IRQ Resources	66
PC Health Status	67
Frequency Control	68
Load Default Settings	69
Set Supervisor/User Password	70
Save & Exit Setup	71
Exit Without Saving	72
S.G_Aspire SA80 & AcerPower S280_CH3	73
General Information	74
Before You Begin	74
Standard Disassembly Procedure	75
Opening the System	75
Removing the Front Panel	75
Removing the Cables from Mainboard	75
Disconnect the Cables from Device	77
Removing the ODD, FDD and HDD	77
Removing the USB Module	77
Removing the DIMM	78
Removing the Heatsink and CPU	78
Removing the Mainboard	79
S.G_Aspire SA80 & AcerPower S280_CH4	80
Troubleshooting	80
Power-On Self-Test (POST)	81
POST Check Points	82
POST Error Messages List	88
Error Symptoms List	90
S.G_Aspire SA80 & AcerPower S280_CH5	95
FRU (Field Replaceable Unit) List	95
Exploded Diagram	96

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.