Adaptec 1542B User Manual - Page 11
AHA-1542B
View all Adaptec 1542B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
•S• Section Two Preparation and Configuration 2.3.3 Jumper Block J7 Jumper block J7 is located near the external SCSI connector and is shown below: Pin 1 J7 0 0 X X 0 0 0 0 0 0 0 0 0 0 0 0 Floppy Secondary Address Port Address Select bit 0 Port Address Select bit 1 Port Address Select bit 2 Wait State bit 0 Wart State bit 1 BIOS Address Select bit 0 BIOS Address Select bit 1 x = Jumper Installed Pin pair 1 is the topmost pair of pins 2.3.3.1 Floppy Secondary Address When a jumper is installed in pin pair 1 of J7, the floppy disk controller (AHA-1542B) will respond to the secondary I/O port addresses 170 through 177 (hex). The default is jumper removed; floppy controller responds to the standard AT I/O port addresses of 1F0 through 1F7 (hex). 2.3.3.2 Board I/O Port Address Select The starting address of the block of four I/O ports required by the AHA-1540B/1542B is selected by the jumpers in jumper block J7. Pin pair 1 is the topmost pair of pins. The default address is 330 (hex). That port address is required by the BIOS. Other valid port addresses are 334H, 230H, 234H, 134H, and 130, 334, 230, 234, 130, and 134 (hex). These port addresses may be used by device drivers and operating systems that support multiple host adapters. The default address is 330 (hex). AHA-1540B/1542B 2-10 adaptec