Adaptec 1542B User Manual - Page 9
Preparation, Configuration, adaptec
View all Adaptec 1542B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Section Two Preparation and Configuration J9 0 x 000x Ox 000x C O T- CV 'I' LO CD CD CD CD C C C C C C CCCCCC ( CO CO CO CD CO 8 8- 8cr Qcr •cr cc cr 000 Ox 0 00 0000x 000 x = Jumper Installed IRQ 9, 10, 11, 12, 14, 15 - connects the interrupt line to the AT bus. One of these jumpers must be installed in order for the AHA154XB to interrupt the Host. The jumper selected must match the interrupt channel setting in J5. 2.3.1.7 DMA Transfer Speed Default Pin-pairs 12 and 13 of jumper block J5 set the default DMA transfer speed. Installing jumper shunts as shown below will set any of four default DMA transfer speeds. (See Appendix A for system timing requirements.) The default speed is selected after power on or after a hard reset occurs. This speed may also be tuned to allow for the fastest possible transfer (minimum bus on time) for any particular system by using the Host Adapter command Set Transfer Speed. The Host Adapter command overrides the jumper settings. The default is no jumper installed. AHA-15408/15428 2-8 adaptec