Home » Adaptec Manuals » Wireless » Adaptec 2012500 » Manual Viewer

Adaptec 2012500 User Guide - Page 11

This is Your Wireless Access Point, Top View

UPC - 760884140505

View all Adaptec 2012500 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Installation Task List This is Your Wireless Access Point Top View Antennas LEDs The top of your Wireless AP has four clearly labeled status indicator lights (or LEDs). Once your Wireless AP is installed, these LEDs display the status of the network and the condition of your Wireless AP, as described: LED DIAG LAN Wireless Power On LAN connection is made. Ready to receive Wireless connections. Device is on. Off Problem with LAN connection. Problem with WLAN. Device is off. Blinking Updating firmware. Data is being transmitted on LAN. Data is being transmitted on WLAN. - 4

Section	Page
Introduction	9
Kit Contents	9
System Requirements	9
Installation Task List	10
Before You Begin	10
This is Your Wireless Access Point	11
Top View	11
Side View	12
Installing Your WirelessAP	13
Locating Your WirelessAP	13
Installing the WirelessAP	14
Installing the Wireless Access Point Utility	15
Setting Your WirelessAP’s IP Address	19
Opening the Utility and Logging on	20
Connecting to the WLAN	21
Using Only Adaptec Wireless Products	21
Adding to an Existing WLAN or Using Your WirelessAP With Non-Adaptec Brand Wireless Devices	22
Checking Your Wireless Connections	25
Using the Wireless Access Point Utility	26
Changing the Set-up of Your WLAN	27
Changing the Transfer Rate	28
Changing the WEP Encryption Settings	29
Setting New WEP Keys	30
About Security Authentication Settings	31
Filtering MAC Addresses	32
To delete a MAC address:	33
Changing the Administration Password	33
Rebooting Your WirelessAP	34
Adjusting the Threshold Control Settings	34
Troubleshooting	35
About Wireless Technology and LANs	37
What’s a LAN?	37
What’s a Wireless LAN?	37
How Do I Create a Basic WLAN?	37
What About Security?	38
Technical Specifications	39