Adaptec 2012500 User Guide - Page 33

To delete a MAC address:, Changing the Administration Password

Get Adaptec 2012500 - Ultra Wireless Access Point PDF manuals and user guides
UPC - 760884140505
View all Adaptec 2012500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

Changing the Set-up of Your WLAN 7 Click Save. Your changes are saved. You must reboot your Wireless AP to apply your changes. Click Reboot on the Success page, or continue working in the Wireless Access Point Utility and click Reboot from the Administration page (see page 27) at the end of your session. You do not have to reboot your computer. To delete a MAC address: 1 In the Addresses to Allow box, click on the MAC address. 2 Click Remove Selected. 3 Click Save. Your changes are saved. You must reboot your Wireless AP to apply your changes. Click Reboot on the Success page, or continue working in the Wireless Access Point Utility and click Reboot from the Administration page (see page 27) at the end of your session. You do not have to reboot your computer. Changing the Administration Password By default, no password is set for the Wireless Access Point Utility. However, to increase network security and prevent unauthorized users from accessing your Wireless AP, you should set an Administration password. To change the Administration password: 1 Open the Wireless Access Point Utility and log on. (See page 12.) 2 Click the Administration tab. 3 Type your new password in the top Change Password box, then re-enter it in the box below. 4 Click Reboot. (You do not have to reboot your computer.) 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
26
Changing the Set-up of Your WLAN
7
Click
Save
.
Your changes are saved. You must reboot your Wireless AP to
apply your changes. Click
Reboot
on the Success page, or
continue working in the Wireless Access Point Utility and click
Reboot from the Administration page (see
page 27
) at the end of
your session. You do not have to reboot your computer.
To delete a MAC address:
1
In the
Addresses to Allow
box, click on the MAC address.
2
Click
Remove Selected
.
3
Click
Save
.
Your changes are saved. You must reboot your Wireless AP to
apply your changes. Click
Reboot
on the Success page, or
continue working in the Wireless Access Point Utility and click
Reboot from the Administration page (see
page 27
) at the end of
your session. You do not have to reboot your computer.
Changing the Administration Password
By default, no password is set for the Wireless Access Point Utility.
However, to increase network security and prevent unauthorized
users from accessing your Wireless AP, you should set an
Administration password.
To change the Administration password:
1
Open the Wireless Access Point Utility and log on. (See
page
12
.)
2
Click the
Administration
tab.
3
Type your new password in the top Change Password box, then
re-enter it in the box below.
4
Click
Reboot
. (You do not have to reboot your computer.)