Adaptec 2060100 User Guide - Page 77

Adaptec Ultra320 SCSI Cards User's Guide Installing the Device Driver for Windows To begin driver installation, see either, Installing the Driver For a Fresh Installation of Windows on page 5-2, or Installing the Driver When Windows 2000 or Windows Server 2003 is Already Installed on page 5-3. Installing the Driver For a Fresh Installation of Windows 1 Create a Windows driver disk. See Appendix D, Creating Driver Floppy Disks for more information. 2 Start the system and then press Ctrl-A to enter the SCSISelect utility. Use SCSISelect to create the array and logical drive to which you will install Windows. 3 After the array is built, insert the Windows setup CD in the CD-ROM drive and restart the system to begin the Windows installation. Note: When using a CD-ROM drive to install Windows 2000, Windows Server 2003, or Windows XP from the bootable CD, make sure Bootable CD-ROM support is enabled. This is done through the System BIOS Setup Utility. 4 Press F6 when this message is displayed: Press F6 if you need to install third-party SCSI or RAID drivers 5 Press S = Specify Additional Device. 6 Insert the Windows driver disk you created, when the setup prompts you to insert the manufacturer supplied disk into drive A, and then continue. 7 The screen displays the adapter drivers supported on the disk. Select Adaptec HostRAID U320 Driver for Windows 2000/ 2003/ XP. 8 Your system will restart once more to finish setting up Windows. 5-2