Adaptec 2221000 Quick Installation Guide - Page 7
Step 2: Installing the Drive Carriers
UPC - 760884149805
View all Adaptec 2221000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3 Remove the tower's front bezel, as shown below, saving the screws for use in Step 5. Step 3 Step 4 4 Turn the enclosure 90° so that the right hand rack mount ear and LEDs are on top, then slide the Storage Enclosure into the tower skin, as shown above. 5 Replace the front bezel, using the screws removed in Step 3. 6 Install the tower labels at the top and bottom of the tower. Align the holes in the top label with the LEDs on the enclosure. 7 Replace the drive carriers and APCs, if necessary. The tower assembly installation is complete. Continue with Step 2: Installing the Drive Carriers, below. Step 2: Installing the Drive Carriers These instructions assume that the drive carriers have already been attached to your disk drives. ! Caution: Acclimate new disk drives to room temperature before you install them and power up the Storage Enclosure. To install the drive carriers into the Storage Enclosure: 1 Hold the drive carrier with the LEDs on the left side (at the bottom for tower-mounted systems) and select an open disk drive slot. Note: It is easiest to install the drive carriers from left to right on the Storage Enclosure. 6