Adaptec 52445 Quick Start Guide - Page 9
Step 4 Create the Driver Disk, Step 5 Install the Controller Driver with the Operating System - linux
UPC - 760884155653
View all Adaptec 52445 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
English Step 4 Create the Driver Disk a Insert the Adaptec RAID Installation CD and turn on the computer to boot from the CD. b Follow the on-screen instructions to display the CD's menu. c Click Create Driver Disk, then select your operating system. If you selected Linux, you may also need to select an architecture (depending on the type of Linux you selected). d Select your floppy disk drive letter, then select the format you want. You need a full format only if your floppy disk is unformatted. e Insert the floppy disk, then click OK. The computer creates the driver disk. f Remove and label the driver disk. g Continue with the installation of the operating system and controller driver, as described in Step 5 below. If your operating system is not listed in Step 5, refer to the Adaptec RAID Controller Users Guide on the RAID Installation CD. Step 5 Install the Controller Driver with the Operating System Windows 2003/XP a Insert your Windows CD, then restart the computer. b Follow the on-screen instructions to begin the Windows installation. c When prompted to install a third-party driver, press F6. Note: When F6 is active, a prompt appears at the bottom of the screen for only 5 seconds. If you miss your chance to press F6, restart your computer. d Insert the driver disk, then wait until prompted to install the driver. Press S to specify that the driver is on the floppy disk, then press Enter. The computer reads the disk. e When the driver is found, press Enter. Follow the on-screen instructions to complete the installation. 5