Adaptec 5325301846 Configuration Guide - Page 17

SnapServer® Configuration Guide 6 Purchasing Guide 6.1 Scalable Systems, Expansion, Drives, System Specific Software The tables below provide ordering information to configure SnapServer N2000 and 620 series servers as well as SnapServer Expansion E2000 and S50 expansions with a common drive type throughout. However, any available drive type may be used in the expansion shelf provided all drives are common within a RAID set. Following the expansion storage are additional tables for Snap EDR software specific to scalable systems. Snap EDR Software for Non-SnapServer NAS Systems are addressed in later sections of the Purchasing Guide. 6.1.1 Configuring SnapServer N2000 Solutions The following steps can be used as guidance for configuring a scalable SnapServer N2000 solution. Step 1 Step 1a Choose and Configure a Base SnapServer N2000 System Choose a scalable SnapServer N2000 system OV-NAS101007 SnapServer N2000, 0-DRIVE Step 1b Step 1c Step 1d To populate a SnapServer N2000 with internal capacity, choose up to 12 drives SAS Drive 4-Packs (15K RPM) OV-ACC901013 HDD - S2000/N2000/E2000, 600GB SAS w/ Carrier, 4 Pack OV-ACC901016 HDD - S2000/N2000/E2000, 300GB SAS w/ Carrier, 4 Pack SAS Drive Single (15K RPM) OV-ACC901019 HDD - S2000/N2000/E2000, 600GB SAS w/ Carrier OV-ACC901020 HDD - S2000/N2000/E2000, 300GB SAS w/ Carrier SATA II Enterprise Drive 4-Packs (7200 RPM) OV-ACC901012 HDD - S2000/N2000/E2000/4600, 2TB SATA ENT w/ Carrier, 4 Pack OV-ACC901011 HDD - S2000/N2000/E2000/4600, 1TB SATA ENT w/ Carrier, 4 Pack SATA II Enterprise Drive Single (7200 RPM) OV-ACC901018 HDD - S2000/N2000/E2000/4600, 2TB SATA ENT w/ Carrier OV-ACC901017 HDD - S2000/N2000/E2000/4600, 1TB SATA ENT w/ Carrier SATA II Desktop Drive 4-Packs (7200 RPM) OV-ACC901024 HDD - N2000/E2000, 2TB SATA DT w/ Carrier, 4 Pack OV-ACC901023 HDD - N2000/E2000, 1TB SATA DT w/ Carrier, 4 Pack SATA II Desktop Drive Single (7200 RPM) OV-ACC901027 HDD - N2000/E2000, 2TB SATA DT w/ Carrier OV-ACC901026 HDD - N2000/E2000, 1TB SATA DT w/ Carrier NOTE: Each SnapServer N2000 enclosure may be configured with 4 to 12 drives. Drives must be the same rotational speed within a vertical column in the SnapServer N2000 shelf If additional Ethernet connectivity is desired, select one of the following PCIe Ethernet cards. (A maximum of six 1GbE ports are supported) OV-ACC901005 ACC - PCIe Card, Dual Port Gig/E Card OV-ACC901015 ACC - PCIe Card, Quad Port Gig/E Card Add a SCSI HBA for tape connectivity (if desired) OV-ACC901008 ACC,PCIe,SCSI,U320 17 For the latest version of this document, please go to: http://www.overlandstorage.com/pdfs/SnapServer_NAS_Config_Guide.pdf ©2011 Overland Storage. All trademarks and registered trademarks are the property of their respective owners. The information contained herein is subject to change without notice and is provided "as is" without warranty of any kind. Overland Storage shall not be liable for technical or editorial errors or omissions contained herein.