Airlink AML001 Manual - Page 52
ER Error Control Reporting Intermediate Result Codes, ER Control Reporting Commands
![]() |
View all Airlink AML001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Appendix A AT Commands +ER Control Reporting Commands: +ER=0 This command enables error control report (default). +ER=1 This command disables error control report. +ER Error Control Reporting Intermediate Result Codes +ER: NONE +ER: LAPM +ER: ALT Data compression not in use. V.42 LAPM protocol is in use. V.42 alternative protocol is in use. +ES=,,-Error Control Selection Use this command to select the error correction mode. If the modem is operated in V.80 mode (synchronous buffered mode), and +ES=,,8, the +ES? will always return +ES: 6,,8. The setting of this command overwrites the \N command. However, the +ES command is overwritten by the setting on a \N command. +ES Combinations: +ES=1,0,1 +ES=0,1,0 +ES=4,4,6 +ES=3,3,5 +ES=4,0,6 +ES=3,0,2 +ES=2,0,2 +ES=3,2,4 +ES=,,8 +ES=6,,8 Buffered mode. Direct mode. MNP or disconnect mode. LAPM or disconnect mode. MNP or buffered mode. LAPM, MNP, or buffered mode (default). LAPM or buffered mode. LAPM, MNP, or disconnect mode. V.42 sync buffer mode (V.80 enabled). V.42 sync buffer mode (V.80 enabled). +ESR=-Selective Repeat Use this command to enable or disable the selective reject mode. 0 Enables the selective reject mode. 1 Disables the selective reject mode. 51
![](/manual_guide/products/airlink-aml001-manual-74b090b/52.png)