Alesis Recital 61 Recital 61 User Guide v1.1 - Page 13

Auto Power Off In order to save energy, the Recital 61 Digital Piano will automatically shut down after 30 minutes if it is not used. To enable or disable the Auto Power Off function: 1. Press the Metronome and Lesson buttons at the same time to enter Advanced Function Mode. The button LEDs will be lit. 2. Following the diagram on page 7, use the key marked Auto Pwr to enable or disable the Auto Power Off function. 3. Press both the Metronome and Lesson buttons again to exit Advanced Function Mode. Restore Factory Default Settings To restore your Recital 61 to the factory default settings, press and hold the Layer and Lesson buttons for 5 seconds. All settings will be reset to their default values. Note: Recital 61 cannot be in Advanced Function Mode when you restore it to the factory default settings. Troubleshooting Problem The speakers produce a pop sound whenever the power is turned on/off. The speakers do not produce sound when the keys are played. The speakers are producing noise or interference. Certain notes produce the wrong pitch. Possible Cause and Solution This is normal and is no cause for alarm. Check if the master volume is set too low or if headphones are plugged into the Headphone Output. The speakers will be muted if there are headphones plugged into the Headphone Output. If the issue is still occurring, press and hold the Layer and Lesson buttons for 5 seconds to factory reset the voice volume settings of the unit. Using a mobile phone in close proximity to the Recital 61 Digital Piano may produce interference. To prevent this, turn off the mobile phone or keep it away from the piano. Make sure that the transpose value is set to 0. If that does not work, then press and hold the Layer and Lesson buttons for 5 seconds to restore the factory default settings. The notes sound weak or distorted. If the keyboard is being powered with batteries, make sure new batteries are installed. 13