Alpine CDE 102 Cde-102 Owner′s Manual (english) - Page 15

Setting the Treble Control You can change the Treble Frequency emphasis to create your own tonal preference. 1 Press SOUND/SETUP repeatedly to select the TREBLE mode. BASS TREBLE HPF BASS Setting the Treble Center Frequency 2-1 Press BAND to select the desired treble center frequency. 10.0 kHz 12.5 kHz 15.0 kHz 17.5 kHz 10.0 kHz Emphasizes the displayed treble frequency ranges. Setting the Treble Level 2-2*2Turn the Rotary encoder to select the desired treble level (-7~+7). You can emphasize the treble level. 3 Press and hold /ESC for at least 2 seconds to return to normal mode. • If no operation is performed for 15 seconds, the unit will return to normal mode automatically. • The treble level settings will be individually memorized for each source (FM, AM, CD, etc.) until the setting is changed. The Treble frequency settings adjusted for one source are effective for all other sources (FM, AM, CD, etc.). • The function is inoperable when DEFEAT is set to ON. *2 The adjustment can also be made by pressing Rotary encoder. Refer to "Adjusting Subwoofer Level/Bass Level/Treble Level/ Balance (Between Left and Right)/Fader (Between Front and Rear)/ Defeat" (page 12). Turning Loudness On/Off Loudness introduces a special low- and high-frequency emphasis at low listening levels. This compensates for the ear's decreased sensitivity to bass and treble sound. Press and hold Rotary encoder (LOUD) for at least 2 seconds to activate or deactivate the loudness mode. • The function is inoperable when DEFEAT is set to ON. Adjusting the High Pass Filter The High Pass Filter on this unit can be adjusted to suit your personal taste. 1 Press SOUND/SETUP repeatedly to select the HPF mode. BASS TREBLE HPF BASS 2 Turn the Rotary encoder to select the desired HPF frequency. OFF 60 Hz 80 Hz 100 Hz All frequencies above the selected cutoff are output. 3 Press and hold /ESC for at least 2 seconds to return to normal mode. • If no operation is performed for 15 seconds, the unit will return to normal mode automatically. • The function is inoperable when DEFEAT is set to ON. 13-EN