Alpine IDA-X303 Ida-x303 Owner's Manual (english) - Page 8

Getting Started Double Action encoder FUNCTION/SETUP Attaching 1 Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit. 2 Push the left side of the front panel until it locks firmly into the main unit. SOURCE /ENTER VIEW Accessory List • Digital Media receiver 1 • Power cable 1 • USB cable 1 • Interface cable for iPod 1 • Mounting sleeve 1 • Carrying case 1 • Bracket key 2 • Screw (M5x8 4 • Owner's Manual 1 set Turning Power On and Off Press SOURCE to turn on the unit. • The unit can be turned on by pressing any other button except (Release), Double Action encoder and VIEW. The unit is also automatically turned on if a USB memory/iPhone/iPod is connected. Press and hold SOURCE for at least 2 seconds to turn off the unit. • The first time power is turned on, the volume will start from level 12. Detaching and Attaching the Front Panel Detaching 1 Turn off the unit power. 2 Press (Release) at the middle left side until the front panel pops out. 3 Grasp the left side of the front panel and pull it out. • Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit. • Attach the front panel carefully. Hold the panel by its sides to avoid pushing any buttons by mistake. Initial System Start-Up Be sure to press the RESET switch when using the unit for the first time, after changing the car battery, etc. 1 Turn off the unit power. 2 Press (Release) to remove the front panel. 3 Press RESET with a ballpoint pen or similar pointed object. Adjusting Volume Turn the Double Action encoder until the desired sound is obtained. • The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel). This is not a malfunction. • To protect the front panel, place it in the supplied carrying case. 6-EN