Alpine IVE-W530 Owner's Manual (english) - Page 47

Auxiliary Device (Optional) Operating Auxiliary Devices (Optional) To operate your devices connected to the AUX1, AUX2 or Front AUX terminals, follow the procedure described below. WARNING It is dangerous (and illegal in many states) for the driver to watch the Video while driving the vehicle. The driver may be distracted from looking ahead and an accident could occur. Install the IVE-W530 correctly so that the driver cannot watch Video unless the vehicle is stopped and the emergency brake is applied. If the IVE-W530 is not installed correctly, the driver will be able to watch the Video while driving the vehicle and may be distracted from looking ahead and cause an accident. The driver or other people could be severely injured. To activate your auxiliary devices: To watch a video source, your vehicle must be parked with the ignition key in the ACC or ON position. To do this, follow the procedure below. 1 Bring your vehicle to a complete stop at a safe location. Engage the parking brake. 2 Keep pushing the foot brake and release the parking brake once then engage it again. 3 When the parking brake is engaged for the second time, release the foot brake. • For automatic transmission vehicles, place the transmission lever in the Park position. Now, the locking system for the AUX mode operation has been released. Engaging the parking brake can reactivate the AUX mode, as long as the car's ignition has not been turned off. It is not necessary to repeat the above procedure (1 through 3), of "To activate your auxiliary devices". Each time the ignition is turned OFF, perform the procedure of "To activate your auxiliary devices". • If you try to activate the auxiliary device while driving, the display will show the warning-Picture off for your safety. 1 Press SOURCE/ . The Source Selection screen is displayed. 2 Touch [Aux-1]*, [Aux-2] or [Front AUX]. The external input screen is displayed. 3 Touch [NTSC/PAL] to change the video input. This step is not applicable to Front AUX mode. * The name which is given as the source name in "Setting the AUX Mode" on page 37 is displayed. • If the AUX mode is not displayed on the main menu, set AUX1 IN to ON or AUX2 IN to AUX by following "Setting the AUX Mode" (page 37). Or set AUX Front to ON by following "Setting the AUX Front Mode" on page 38. • The setting of switching NTSC/PAL, which you have set in this section, can be used in same way in "Setting the AUX Mode" on page 37. • The display mode changes by touching [WIDE]. For operation, refer to "Switching Display Modes" on page 28. 47-EN