Alpine IVE-W530 Owner's Manual (english) - Page 65

Antenna Receptacle Video Input Connector (AUX IN) (Yellow) Input the AUX video. • To use this function, turn on "AUX1 IN" in the "SETUP" menu (see "Setting the AUX Mode" (page 37)). Audio Input Connector (AUX IN) RED is down and WHITE is up input the audio. Video Output Connector (AUX OUT) (Yellow) Output the video. Audio Output Connectors (AUX OUT) RED is down and WHITE is up output the audio. Front Output RCA Connectors RED is left and WHITE is right. Rear Output RCA Connectors RED is left and WHITE is right. Subwoofer Output RCA Connectors RED is left and WHITE is right. RCA Extension Cable (sold separately) Fuse Holder (15 A) Power Supply Connector Remote Turn-On Lead (Blue/White) Connect this lead to the remote turn-on lead of your amplifier or signal processor. Power Antenna Lead (Blue) Connect this lead to the +B terminal of your power antenna, if applicable. • This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc. Parking Brake Lead (Yellow/Blue) Connect this lead to the power supply side of the parking brake switch to transmit the parking brake status signals to the IVE-W530. Foot Brake Lead (Yellow/Black) Connect to the vehicle's foot brake lead or brake lamp lead. Remote Control Output Lead (White/Brown) Connect this lead to the remote control input lead. This lead outputs the controlling signals from the remote control. Switched Power Lead (Ignition) (Red) Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides (+) 12 V only when the ignition is turned on or in the accessory position. Battery Lead (Yellow) Connect this lead to the positive (+) post of the vehicle's battery. Ground Lead (Black) Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided. Right Front (+) Speaker Output Lead (Gray) Right Front (-) Speaker Output Lead (Gray/Black) Right Rear (-) Speaker Output Lead (Violet/Black) Right Rear (+) Speaker Output Lead (Violet) Left Rear (+) Speaker Output Lead (Green) Left Rear (-) Speaker Output Lead (Green/Black) Left Front (-) Speaker Output Lead (White/Black) Left Front (+) Speaker Output Lead (White) RGB Input Connector Connect this to the RGB output terminal of the Navigation System. USB Connector Connect this to a Flash Memory device or to an iPod/ iPhone. To use an iPod/iPhone, an iPod interface cable is required. • Use the supplied USB cable. If a USB cable other than the supplied is used, correct performance cannot be guaranteed. • Route the USB cable away from other cables. MIC Input Connector To Microphone Steering Remote Control Interface Connector To steering remote control interface box. For details about connections, consult your nearest Alpine dealer. iPod (V)/AUX Input Connector Input the iPhone/video compatible iPod audio/video signal or AUX video/audio signal. • Set "AUX2 IN" to "iPod Video" in "Setting the AUX Mode" (page 37) when an iPhone or a video compatible iPod is connected. • Set "AUX2 IN" to "AUX" in "Setting the AUX Mode" (page 37) when normal AUX video/audio is input. CAMERA Input Connector Use when the optional rearview camera with RCA Connector is connected. • Set "ON" in "Setting the Rear Camera Input" (page 36) when connecting a rearview camera with RCA output connector. Microphone (Included) Reverse Lead (Orange) Use only when a back-up camera is connected. Connect to the plus side of the car's reverse lamp. This lamp illuminates when the transmission is shifted into reverse (R). With this lead properly wired, the video picture automatically switches to the back-up camera whenever the car is put into reverse (R). 65-EN