Alpine PSS-24WRA Install Manual - Page 10

Jeep Wrangler PSS-24WRA V20211025 ˜ 10/15 Sub Woofer/Amp Installation 1 Extract (4) T50 Torx Screws from the passenger side seat. Front of Vehicle 2 Tilt the passenger seat towards the back to reveal (2) connectors, disconnect and remove the seat. 3 Connect the power cable to the Positive (+) battery terminal and route the cable down towards frame of the vehicle. 4 Route the power cable following the factory harness along the vehicle's frame and secure using supplied cable ties. 5 Route the Positive (+) power cable through the grommet under the carpet and pull the power cable from under the vehicle. Note: seal the grommet with silicone (not included) to prevent water from entering the cabin. 6 Mount the subwoofer level remote on the center console next to the gear shifter and route the cable to the passenger side seat. Plug 3.5mm plug into the bass knob input of the PWE-S8. Front of Vehicle