Alpine VPX-B104R Owners Manual - Page 16
Installation, On-Screen, Display
View all Alpine VPX-B104R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Installation of ECU On-Screen Display Set Up 1 Align the calibration paper behind the car, and up to the rear wheel. Align the 0 ft mark with the rear bumper. Calibration sheet Line up bumper with 0 ft 1 Mount the ECU on a dry, protected area inside the vehicle. For example, behind the trunk panels or under the seats. 2 Connect the red wire to the ACC (+), the black wire to ground(-) of vehicle. 3 Connect reverse signal{+) to the orange/white wire. Calibration sheet 2 On screen color with distance obstacle: RED (less than 1.5 ft), YELLOW (1.5- 3ft), GREEN (3-6ft). 3 Press the [ENT] and [+] buttons for 5 seconds continuously to enter the On-Screen Display set-up mode. 4 Each item in the [Setup mode] can be selected by pressing the [+], [-] and [ENT] buttons. Following items can be adjusted in Setup mode. 1. Fish-eye correction 2. Parking Guide Line 3. Diagnostic 4. Exit 15-EN