Ariens Hydro Pro 32 Owners Manual - Page 22

GENERAL LUBRICATION, Auger Shaft

Get Ariens Hydro Pro 32 PDF manuals and user guides View all Ariens Hydro Pro 32 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

GENERAL LUBRICATION (Figure 18) IMPORTANT: Wipe each fitting clean before and after lubrication. IMPORTANT: DO NOT allow grease or oil to get on belts. NOTE: Apply Ariens Hi-Temp Grease or equivalent to the lubrication fittings. See SERVICE PARTS on page 31. Sno-Thro should be lubricated (Figure 18) at beginning of season or every 25 operating hours. Auger Shaft To grease auger shaft, remove shear bolt nuts and shear bolts per instructions in Shear Bolts on page 23. Apply grease at the grease zerks and then turn the auger assemblies on the auger shaft. Replace shear bolts. Apply oil to auger shaft end bushings. Oil Grease Figure 18 EN - 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
EN - 22
GENERAL LUBRICATION
(Figure 18)
IMPORTANT:
Wipe each fitting clean before
and after lubrication.
IMPORTANT:
DO NOT allow grease or oil to
get on belts.
NOTE:
Apply Ariens Hi-Temp Grease or
equivalent to the lubrication fittings. See
SERVICE PARTS
on page 31
.
Sno-Thro should be lubricated (Figure 18) at
beginning of season or every 25 operating
hours.
Auger Shaft
To grease auger shaft, remove shear bolt
nuts and shear bolts per instructions in
Shear
Bolts
on page 23. Apply grease at the grease
zerks and then turn the auger assemblies on
the auger shaft. Replace shear bolts.
Apply oil to auger shaft end bushings.
Figure 18
Oil
Grease