Asus H610T-EM-A User Manual English - Page 41

[None] [Even] [Odd] [Mark] [Space] Disables parity check. Parity bit is 0 if the num of 1's in the data bits is even. Parity bit is 0 if the num of 1's in the data bits is odd. Parity bit is always 1. Parity bit is always 0. Mark and Space Parity do not allow for error detection. Stop Bits Stop bits indicate the end of a serial data packet. The standard setting is 1 stop bit. Communication with slow devices may require more than 1 stop bit. Configuration options: [1] [2] Flow Control Flow control can prevent data loss from buffer overflow. When sending data, if the receiving buffers are full, a "stop" signal can be sent to stop the data flow. Once the buffers are empty, a "start" signal can be sent to re-start the flow. Hardware flow control uses two wires to send start/stop signals. Configuration options: [None] [Hardware RTS/CTS] VT-UTF8 Combo Key Support Allows you to enable or disable VT-UTF8 Combination Key Support for ANSI/ VT100 terminals. Configuration options: [Disabled] [Enabled] Recorder Mode With this mode enabled only text will be sent. This is to capture Terminal data. Configuration options: [Disabled] [Enabled] Resolution 100x31 Allows you to enable or disable extended terminal resolution. Configuration options: [Disabled] [Enabled] Putty KeyPad Allows you to select FunctionKey and KeyPad on Putty. Configuration options: [VT100] [LINUX] [XTERMR6] [SCO] [ESCN] [VT400] 3.3.7 SATA Configuration This item allows you to configure SATA device options settings. SATA Controller(s) Allows you to enables or disables the onboard SATA device. Configuration options: [Disabled] [Enabled] The following item appears only when you set SATA Controller(s) to [Enabled]. SATA Mode Selection Allows you to determine how SATA controller(s) operate. Configuration options: [AHCI] Chapter 3: BIOS setup 3-7