Asus Hummingbird User Guide - Page 80
Setting the RAID item in BIOS, Installing hard disk drives
View all Asus Hummingbird manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
5.1.2 Installing hard disk drives The motherboard supports Serial ATA for RAID set configuration. For optimal performance, install identical drives of the same model and capacity when creating a disk array. To install the SATA hard disks for RAID configuration: 1. Install the SATA hard disks into the drive bays following the instructions in the system user guide. 2. Connect a SATA signal cable to the signal connector at the back of each drive and to the SATA connector on the motherboard. 3. Connect a SATA power cable to the power connector on each drive. 5.1.3 Setting the RAID item in BIOS You must set the RAID item in the BIOS Setup before you can create a RAID set from SATA hard disk drives attached to the SATA connectors supported by Marvell® 6121 chipset. To do this: 1. Enter the BIOS Setup during POST. 2. Go to the Advanced Menu > Chipset, then press . 3. Set Marvell Storage Controller to [RAID Mode], and Marvell Storage Boot ROM to [Enabled]. 4. Press to save your changes and exit the BIOS Setup. Refer to Chapter 4 for details on entering and navigating through the BIOS Setup. 5-4 Chapter 5: RAID configuration